Author Topic: S-10 u-joint to 9 inch ford  (Read 2455 times)

0 Members and 1 Guest are viewing this topic.

Offline dart340x

  • Newbie
  • *
  • Join Date: Aug 2010
  • Posts: 13
S-10 u-joint to 9 inch ford
« on: February 24, 2015, 04:10:38 PM »
Putting a 9 inch ford in an s-10 pick up and need to find a u-joint that will work. Is there a cross over for this Thanks

Offline Tye

  • Sr. Member
  • ****
  • Join Date: Dec 2010
  • Posts: 297
  • Location: lake city
  • You can tear it up but you can't tear it back toge
Re: S-10 u-joint to 9 inch ford
« Reply #1 on: February 24, 2015, 06:46:13 PM »
Yep put a 9 in my camaro a couple of years ago not sure of the part # but i think it was a precision 3310.
Run it till the rods hang out!

Offline Ed

  • Full Member
  • ***
  • Join Date: Nov 2014
  • Posts: 131
Re: S-10 u-joint to 9 inch ford
« Reply #2 on: August 16, 2017, 11:49:45 AM »
I know this is old as hell for a post, but your best bet would be to have a new driveshaft made with 1350 U-joints and get the pinion piece to allow a 1350 u-joint.

the smaller u-joints will snap off and wind up tearing up the driveshaft, the coupler out of the rear end, and possibly the tailshaft housing of the trans.