Author Topic: S-10 u-joint to 9 inch ford  (Read 4043 times)

0 Members and 1 Guest are viewing this topic.

Offline Ed

  • Full Member
  • ***
  • Join Date: Nov 2014
  • Posts: 132
Re: S-10 u-joint to 9 inch ford
« on: August 16, 2017, 11:49:45 AM »
I know this is old as hell for a post, but your best bet would be to have a new driveshaft made with 1350 U-joints and get the pinion piece to allow a 1350 u-joint.

the smaller u-joints will snap off and wind up tearing up the driveshaft, the coupler out of the rear end, and possibly the tailshaft housing of the trans.