MidsouthRacers.com

Tech Section => Rear End Tech => Topic started by: dart340x on February 24, 2015, 04:10:38 PM

Title: S-10 u-joint to 9 inch ford
Post by: dart340x on February 24, 2015, 04:10:38 PM
Putting a 9 inch ford in an s-10 pick up and need to find a u-joint that will work. Is there a cross over for this Thanks
Title: Re: S-10 u-joint to 9 inch ford
Post by: Tye on February 24, 2015, 06:46:13 PM
Yep put a 9 in my camaro a couple of years ago not sure of the part # but i think it was a precision 3310.
Title: Re: S-10 u-joint to 9 inch ford
Post by: Ed on August 16, 2017, 11:49:45 AM
I know this is old as hell for a post, but your best bet would be to have a new driveshaft made with 1350 U-joints and get the pinion piece to allow a 1350 u-joint.

the smaller u-joints will snap off and wind up tearing up the driveshaft, the coupler out of the rear end, and possibly the tailshaft housing of the trans.